Marathon Sprint Series Instruções de Operação descarregar pdf (Página 11)

Montage sprint / marathon

Trim (e.g. saw off and debur) projecting part of ceiling bracket (4).

• Release rear cut-off buffer (1) and push right back to stop (2). Open

door (3) by hand.

• Push cut-off buffer (1) right up to bogie unit (5). Securely tighten

screw on cut-off buffer (1).

Fitting and connecting push-button

Position the push-button in such a way that the operator can see

the door, while he/she is not inside the operating area of the

door.

• Never run button cable (length 7 m) along a power cable as this can

cause the control unit to malfunction. The control unit is shipped with the

button cable connected.

• Lay button cable and secure in position.

• Install push-button (1) in an appropriate, easily accessible location

inside the garage. Minimum height from floor - 1.6 m.

• Install push-button cable (2) in garage. Connect end of cable to

push-button (1).

1,6m

max. 30°

Installing the socket outlet

Socket may only be installed by a qualified electrician. Protect

socket with a fuse (16 A slow-blow type).

Observe all applicable regulations (e.g. VDE, etc.)!

• Install socket (1) on ceiling at a distance of approx. 0.5 meters to the

control unit housing (2).

• Install and connect the line from the power socket (1) to the power

mains.

Do not plug the connector (3) into the socket outlet yet!

ca. 0,5m

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 34 35

Sem comentários

Marathon Sprint Series Instruções de Operação Página 11