Marathon MAGNUM ROUTER Manual do Operador descarregar pdf (Página 38)

FINE VOLTAGE ADJUSTMENT

Adjustment of the output voltage from the generator is necessary to provide the correct voltage to the end of the

power line. Voltage adjustment can be carried out at any time on the Voltage Adjust screen.

1. With the unit running, press .

2. Press . The voltages displayed will begin flashing.

3. Use ▲ and ▼ to adjust the voltage.

4. Press  to confirm the new voltage. The voltages displayed will stop flashing.

SHUTTING DOWN THE UNIT

Check with personnel using power supplied by the generator and let them know that the power is going to be turned

off. Make sure the power shut down will not create any hazards by accidentally turning off equipment that needs to

be kept on (pumps, compressors, lights, etc.).

1. Remove all loads from the generator by opening all circuit breakers (turn to the OFF (O) position).

2. Let the engine run for approximately five minutes to allow it to cool down.

3. Push O. Pressing the red Engine Stop/Reset (O) button will result in the generator going into the shutdown cycle

and starting a 15 second shutdown timer called stopping. If the unit does not shut down within 15 seconds, a

stop fail alarm will be displayed on the LCD window.

4. After the unit shuts down, move the Control Power switch to the OFF (O) position.

Note: For extended storage time, disconnect the battery. Refer to the engine operator’s manual for extended storage

requirements.

EXHAUST FILTER CLEANING OPERATIONS

When enabled, the exhaust filter system goes through an automatic cleaning process known as regeneration. Under

normal circumstances, regeneration occurs without interruption of unit operation and with minimal operator involve-

ment. In the event there are conditions requiring the operation of the unit with the auto exhaust filter cleaning disabled,

the operator may be required to perform procedures to enable or disable the auto exhaust filter cleaning. The operator

may also be required to perform a manual regeneration. The following procedures describe how to perform these

functions.

00396

Manual Mode

GEN

Voltage Adjust

- Press , voltage will begin flashing

- Use and arrows to adjust voltage

- Press to confirm new voltage. Numbers will stop flashing

L-N Average

L-L Average

480

277

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 59 60

Sem comentários

Marathon MAGNUM ROUTER Manual do Operador Página 38