Marathon MAGNUM ROUTER Manual do Operador descarregar pdf (Página 32)

other shut down, refer to “Shutting Down the Unit” on page 38.

MANUAL STARTING OF THE UNIT

All units equipped with the Power Zone™ controller will initially start up in Stop mode. Use the following procedure

to start the generator in Manual mode:

1. Move the Control Power switch to the ON (I) position.

DANGER

CARBON MONOXIDE: USING A GENERATOR INDOORS CAN KILL YOU IN MINUTES.

2. The LCD window will show the prestart diagnosis and the controller will load the unit management software.

3. When the software is loaded, the Home screen will be displayed and the controller will be in Stop mode as

indicated at the top of the screen. Press the Auto/Manual Mode ( ) button to enter Manual mode.

Note: The controller can be started from any screen when it is in Manual mode.

4. Pressing the green Engine Start (I) button on the controller will initiate the startup procedure and start the engine,

provided there are no engine faults preventing the unit from starting.

Note: It may take a few seconds for the engine to run smoothly and reach its governed operating speed. During this

time, the screen will show a voltage different from that set with the voltage selector switch.

5. If the engine does not start after the first cranking attempt, the engine will pause for 15 seconds to allow the

starter to cool. The LCD window will show “Manual Mode - Crank Rest” at the top of the screen. The engine will

make two more attempts to start for a total of three crank cycles.

00414

82%

Image File Transer...

00415

Stop Mode

3 PHASE

Volts

Amps

0.0 kW

100

110

Time to Empty

15 hr

Full

3/4

1/2

1/4

Empty

GEN

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 59 60

Sem comentários

Marathon MAGNUM ROUTER Manual do Operador Página 32